 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
AncientCityBoatSales.com
Sectional Hard Floor Assembly.
Insert stringers into side edges of floorboards. Side edges of floorboard should
easily fit into C-channel of stringer.
Insert stringers into side edges of floorboards. Side edges of floorboard should
easily fit into C-channel of stringer.
Top View Bottom View Correct stringer position
Please see below step-by-step instruction on assembly of plywood and aluminum
floors.
floors.
Inflate boat about 20% and insert front bow section of the floor.
Insert second and last sections of the floor.
Two middle sections will create roof-like structure.
Step on raised part of two connected floor sections.
Make sure that floor will flatten by spreading inside the boat.
Insert aluminum stringers between boat tubes and floor sections.
Aluminum stringers should interconnect at least two sections of the floor.
Inflate left and right tube of the boat. Use hand pump to finish.
Inflate bow section of the boat. Use hand pump to finish.